What Should I Do If The Feed Extruder Discharge Motor Does Not Rotate?

1. Check the motor fault
The problem of the feed extruder automatic discharge motor not rotating may be caused by a fault in the motor itself. At this time, it is necessary to check whether the motor is ferromagnetic and whether it can operate normally. If the motor itself is damaged, the motor needs to be replaced.
2. Check the power connection
When the feed extruder automatic discharge motor does not rotate, it is also necessary to check the power connection to see if the power supply is normal. If the power connection is abnormal or the power line is short-circuited, the power supply needs to be reconnected.
3. Check the rotating parts of the motor
Check the rotating parts of the feed extruder automatic discharge motor, including motor mechanical parts, drive shaft, pulley, etc. If there is a fault, looseness, cracking, etc., it needs to be replaced in time.

4. Check the automatic discharge motor controller
The feed extruder automatic discharge motor does not rotate may also be caused by a fault in the automatic discharge motor controller. It is necessary to check whether the controller is damaged, whether the wiring is poor, etc., and replace or repair the controller in time.
5. Conclusion
The failure of the automatic feeding motor of the feed extruder to rotate is a serious problem. When using it, it is necessary to check the fault in many aspects and repair and replace the motor, power supply, controller and other equipment in time to ensure the normal operation of the equipment. At the same time, before using the equipment, it is also necessary to understand the use method, maintenance and other knowledge of the equipment to ensure the normal operation of the equipment.