What Should I Do If The Feed Pellet Machine Cannot Produce Normally?

1. The blockage of the feed pellet machine feed port and die hole may reduce the working efficiency of the feed pellet machine
If your feed pellet machine also has low output or does not discharge, you can check whether the feed pellet machine's feed port and screen are blocked. Generally speaking, the feed port of the flat die feed pellet machine is vertical, so if it is blocked, it can be seen more intuitively, but for the ring die feed pellet machine, although it is equipped with a forced feeder, it may also cause feed blockage in the narrow and long conditioner.
The same is true for die hole blockage. Once the die hole is blocked, it is relatively easy to clean if it is mild. If the blockage area is large, it will be more troublesome. Therefore, we recommend that before using the feed pellet machine to pelletize, first use oil to pass the feed pellet machine to ensure lubrication. Before finishing the pelletizing work, also use oil to pass the feed pellet machine to prevent the die hole from being blocked.

2. The impact of feed raw materials on the output of feed pellet machine
We know that feed pellet machine is a dry-in and dry-out feed machine. If the raw materials contain a lot of water, the pellets will not be formed. If the water content is too small, it will be difficult to be pressed together to form pellets. Generally, we require that the moisture content of feed raw materials should not exceed 12% during the pelleting process. If the material is too dry, auxiliary equipment such as conditioner can be used.
3. The gap between the roller and the ring die of the feed pellet machine is not appropriate, resulting in low output of the feed pellet machine
In feed machinery, some accessories will wear out after long-term use. This is the case with the hammer of the feed crusher and the roller in the feed pellet machine. In the long-term backlog of feed, it is inevitable that it will be worn. At this time, it is necessary to check whether the inside of the ring die and the roller are worn, so as to determine the reason for the low output of the feed pellet machine.
3. The gap between the roller and the ring die of the feed pellet machine is not appropriate, resulting in low output of the feed pellet machine. In feed machinery, some accessories will wear out after long-term use, such as the hammer of the feed crusher and the roller in the feed pellet machine. In the process of long-term backlog of feed, it is inevitable to wear out. At this time, it is necessary to check whether the inside of the ring die and the roller are worn, so as to determine the reason for the low output of the feed pellet machine.