What Are The Common Failures Of Feed Pellet Mill?

                     Feed pellet mill output is too low or even not out of the grain or out of a lot of powder, this problem although it does not often occur, but if it occurs, it means that in the pellet mill grinding process did not grind the pressure wheel and grinding disk, may appear similar problems due to the initial use of the grinding disk grinding holes with poor finish, the use of abrasive material to grind a good grinding disk, or use a period of time after the pellet mill will reach the normal output of the output. The output of the pellet mill will reach the normal output after grinding the grinding disk with abrasive or using it for some time.

                     Feed moisture is not well mastered will also affect the pellet mill discharge, raw materials inside the moisture should be mastered in 13% -20%, because the pellet mill has a drying and maturation function, raw materials inside the moisture in the pellet mill pressing process will be dried off, in the pellet mill pressing out of the pellet material, at room temperature under the conditions of shade drying for 5-10 minutes can be bagged. Pellet machine pressure wheel and the gap between the grinding disk is too large, may also be one of the reasons that lead to the pellet machine does not feed, adjust the pressure wheel and the grinding disk gap method, one hand screwed the pressure wheel, adjust the corresponding bolts, adjusted to the two sides of the pressure wheel hard to shake not move, a little bit of a state of tightness, that is, that is to say that the pressure wheel and the grinding disk has been adjusted in place.