How to troubleshoot feed additive equipment?
Leave a message
When using feed additive equipment, equipment failure may occur due to various reasons. This article will introduce the troubleshooting and maintenance methods of feed additive equipment in detail from two aspects: troubleshooting equipment failure and repairing equipment.
Feed additive equipment troubleshooting
Observe the outside of the equipment
When the equipment is abnormal, first observe whether there is obvious damage to the outside of the equipment, such as whether the power plug is connected properly, whether the connecting wire is loose, etc. At the same time, gently move the equipment with your hands to feel whether there is abnormal vibration or looseness.
| Model | Capacity | Power | Dimension | Weight |
| 125 | 80-100kg/h | 3kw | 110*35*70 cm | 95 kg |
| 150 | 120-150kg/h | 4kw | 115*35*80cm | 100 kg |
| 210 | 200-300kg/h | 7.5kw | 115*45*95cm | 300 kg |
| 260 | 500-600kg/h | 15kw | 138*46*100cm | 350 kg |
| 300 | 700-800kg/h | 22kw | 130*53*105cm | 600 kg |
| 360 | 900-1000kg/h | 22kw | 160*67*150cm | 800 kg |
| 400 | 1200-1500kg/h | 30kw | 160*68*145cm | 1200 kg |
Check the automatic control program
In the process of judging equipment failure, it is also very important to check the automatic control program. Because most of the failures are related to the automatic control program, we can use special measuring tools to detect voltage and power, and make comparative analysis.
Dust filter cleaning
The dust filter of the equipment will accumulate a lot of dust and debris after long-term use, affecting its normal operation. Therefore, when troubleshooting, you can first clean or replace the dust filter.
Check the transmission link
Damage to the transmission link is also an important cause of equipment failure. Therefore, when checking, you should pay attention to the tightness of the transmission chain and the wear of the gears. If necessary, you can disassemble, clean, and lubricate it.
