Large Extruder Fish Feed

Before using a large-scale extruder, you need to make adequate preparations. First, check whether the equipment is intact and whether the components are firmly fastened. Secondly, clean the inside of the extruder to ensure that there is no debris left. In addition, prepare the required production raw materials, such as fish meal, soybean meal, corn meal, etc., and mix them according to the formula ratio. Finally, turn on the power to ensure that the extruder can operate normally.

1. Add the mixed raw materials to the feeding hopper of the extruder, and pay attention to evenly add them to avoid excessive accumulation and blockage.
2. Turn on the power of the extruder and start the machine. In the early stage of startup, closely observe the operating status of the extruder to ensure its stable operation.
3. Adjust the temperature and pressure of the extruder, these two parameters are crucial to the quality of the feed. According to the characteristics of the raw materials and the quality of the required feed, the temperature and pressure values ​​should be set reasonably.
4. During the operation of the extruder, the operation of the machine should be checked regularly. If there is any abnormal sound or fault, the machine should be stopped immediately for inspection and troubleshooting.
5. After the feed is extruded, it is cooled by cooling equipment and then packaged and stored.