Soybean Extruded Feed Machine

Feed extruder can produce high-quality extruded feed according to requirements.

Send Inquiry

Description

Products Description

The output is reduced and the expected capacity is not achieved.
This may be caused by the wear of the conical pressure ring or wear ring, and the serious wear of the screw head. At this time, you should consider replacing these worn parts to restore the capacity.
During normal operation, there is a sudden lack of material discharge.
This may be caused by too much feed in a short period of time, or foreign matter blocking the discharge hole. To solve this problem, you need to slow down the feeding speed and stop the machine to clean the foreign matter in the discharge hole.

Product Parameters

Model	Power	Feeder	Cutter	Capacity	Dimension	Weight
DGP40	4KW	0.4KW	0.4KW	0.04-0.05T/H	140010301200MM	240KG
DGP50	11KW	0.4KW	0.4KW	0.06-0.08T/H	140010301200MM	320KG
DGP60	15KW	0.4KW	0.4KW	0.12-0.15T/H	14509501430MM	480KG

The diameter of the expanded particles is too large or too small.
This may be caused by improper die hole size at the discharge end. To solve this problem, the appropriate discharge die hole size should be selected as required.
When processing soybeans, the expanded soybean powder is sprayed back from the feed port.
This may be caused by too much feed too fast, poor discharge or blockage, improper configuration of the screw head and pressure ring, and serious wear of the expansion chamber. To solve this problem, you need to control the feed speed and feed amount, check and adjust the configuration of the screw head and pressure ring, and replace a new expansion chamber.

The product is blocked before it is discharged from the die hole.
This may be due to the fact that the raw material particles are too large, the water volume is insufficient, the extrusion chamber structure is unreasonable, and the pressure ring diameter is too large. To solve this problem, it is necessary to ensure that the raw material is crushed to an appropriate fineness, add water at the beginning of the product entering the expansion cylinder, arrange the pressure ring and screw head reasonably, and replace the pressure ring with a smaller diameter.