Cattle Feed Complete Production Line

1. After the feed production line has been used for a period of time, it should be regularly inspected and cleaned to keep it clean and dry.
2. The transmission parts such as bearings, chains, belts of the feed production line should be regularly lubricated to prevent wear and rust.
3. The electrical part of the feed production line should be regularly checked to see if the circuit, switch, socket, etc. are normal to prevent leakage, short circuit and other faults.
4. The blades, screens and other wearing parts of the feed production line should be replaced or repaired regularly to keep them sharp and intact.
5. When the feed production line is not used for a long time, it should be stored in a dry, ventilated and cool place to avoid direct sunlight or rain.

The calibration and debugging methods are as follows:
1. Check the working status of each instrument according to the instruction manual of the equipment. If there is any abnormality, replace or repair it in time.
2. Use standard instruments or samples to calibrate thermometers, pressure gauges, ammeters and other instruments to ensure that their indicated values ​​are consistent with the actual values.
3. Adjust the parameters of each process, such as temperature, pressure, speed, time, etc., to meet the production requirements of feed.
4. Check the connection and coordination between each process. If there is looseness, air leakage, blockage, etc., deal with it in time.
5. Run the equipment for a period of time, observe its operation and the quality of the feed. If there is a problem, analyze the cause and solve it in time.