What are the easy maintenance methods for a manual small fish food pellet making machine?

Routine cleaning is fundamental to reducing resistance; thorough cleaning is essential after each use of the floating fish feed processor. Many fish farmers, to save time, neglect to clean the equipment after processing feed, leading to clumping and carbonization of residual feed inside the machine. This increases resistance during subsequent uses. The correct cleaning method is as follows: After each processing cycle, first remove the molds and use a specialized cleaning needle to unclog each mold hole and remove any remaining feed. Then, open the machine casing and clean any remaining feed from the pressure rollers and hopper to prevent clumping. Finally, wipe all internal components with a dry cloth to ensure no powder residue remains. It is important to note that you should not wash the equipment with water during cleaning, as this can cause gears and bearings to rust, increasing operating resistance.

 

Regular lubrication of components reduces mechanical wear resistance. The gears, bearings, pressure roller shafts, and other moving parts of manual fish feed pellet processors will wear down over time. Lack of lubrication will exacerbate this wear, increasing operating resistance. It is recommended to perform lubrication maintenance on the equipment weekly: apply an appropriate amount of lithium-based grease to the gear meshing points to reduce gear wear; add 2-3 drops of machine oil to both ends of the bearings and pressure roller shafts to ensure smooth operation of components; apply a small amount of grease to the connection between the hopper and the barrel to prevent raw materials from sticking. When lubricating, be careful not to use excessive amounts of grease or machine oil, otherwise it will contaminate the raw materials and affect feed quality. Also, use dedicated mechanical lubricating oil; do not use edible oil as a substitute, as it may deteriorate and clump at high temperatures.

 

Repair worn parts promptly to prevent continued increase in resistance. The molds and pressure rollers of a manual floating fish feed pellet making machine are vulnerable parts. After long-term use, wear will occur, causing the mold holes to enlarge and the pressure roller surface to become smooth. This not only affects the pellet forming quality but also increases operating resistance. When severe wear of the mold holes is found and the pellet diameter has significantly increased, the mold should be replaced promptly. When the pressure roller surface becomes smooth and cannot effectively drive the raw materials forward, the pressure roller surface can be lightly polished to increase surface friction, or the pressure roller can be replaced directly. In addition, the wear of the gears should be checked regularly. If there is obvious wear or missing teeth on the gear teeth, the gears should be replaced in time, otherwise it will cause the operation to stall and be difficult to crank by hand.

 

 

 

 

MIKIM's fish feed pellet production lines and supporting machinery offer excellent value for money. Not only are they affordable, eliminating middlemen markups and allowing small and medium-sized enterprises (SMEs) and fish farmers to purchase complete sets of equipment at reasonable costs, but they also boast exceptional efficiency. The fully automated process, from raw material crushing and precise ingredient mixing to extrusion pelleting and maturation, is completed in one continuous flow. This results in high starch gelatinization rates and uniform pellet formation, significantly improving production efficiency and feed quality, truly achieving "low cost, high output." Choosing a MIKIM fish feed pellet production line means enjoying comprehensive pre-sales and after-sales service, including 24-hour online customer support, a one-year warranty on the entire machine, professional on-site installation, commissioning, and maintenance, and a stable supply of spare parts. Customers can buy with confidence and use with peace of mind, with both excellent value and service quality!

 

Customer visit

Certificate of Honor

 

 

 

1. What is the price of the  fish feed pellet extruder?

The price ranges from approximately $3,500-$55,000

2. Do you provide maintenance services for your customers?
Yes, we offer comprehensive after-sales maintenance services to our customers.

 

If you would like to learn more about MIKIM machinery, please contact us. We offer one-stop service and welcome your inquiries!!!

Contact now